The cheapest solution for battery pack that can be discharged at a low temperature -20 degrees
December 22, 2020
The cheapest solution for battery pack that can be discharged at a low temperature -20 degrees
Item 18650 battery Pack
Design background:
The battery block can adapt to the low temperature discharge environment. -10--Minus 20 degrees Celsius still needs normal discharge.
Field use of industrial outdoor tablet computers
The product is charged indoors and outdoors when used. So only need to consider that -10--minus 20 degrees Celsius still needs to be discharged normally
Battery Pack ICR18650 11.1V 3350MAH
Single cell LG18650F1L
The cell support low temprature discharge
We can assemble the battery pack with LG18650F1L and Samsung brand lithium cell
2 Through the software board, set the charge protection temperature and discharge protection temperature flexibly.
The parameters of the protection board are shown in the following table.
When the battery charging voltage reaches 4.28V, the protection board is activated, and the battery can no longer be charged in and out, but this protection value is constant and cannot be adjusted.
When the battery voltage reaches 2.7V when the battery is discharged, the protection board is activated and the battery can no longer be discharged, but the protection value is constant and cannot be adjusted.
No | Item | Condition | Specification |
1 | 输入电压/input Voltage | B+/B-间输入电压/input Voltage B+ to B- | -0.3~+24V |
2 |
过充电 Overcharge |
保护电压/Detection voltage/1CELL | 4.28±0.05V |
3 | 恢复电压/ Release voltage/1CELL | 4.08±0.1V | |
4 | 保护延迟时间/ Detection delay time | 0.8~1.6S | |
5 |
过放电 Over discharge |
保护电压/Detection voltage/1CELL | 2.7±0.1V |
6 | 恢复电压/ Release voltage/1CELL | 3.00±0.1V | |
7 | 保护延迟时间/ Detection delay time | 80.00~160.00ms | |
8 |
放电过流 Over discharge current |
放电过流保护电流/Over current | 5-8A |
9 | 放电过流保护延时/delay time | 7.00~20.00ms | |
10 |
短路保护 Short detection |
短路保护延时/ Short detection delay time | 100~350us |
11 | 恢复条件/Release Conditions | 断开负载/Cut off load | |
12 |
充电温度保护 Charge temperature protection |
充电时的温度保护阀值/ Charge temperature protection | 无/NO |
13 |
放电温度保护 Discharge temperature protection |
放电时的温度保护阀值/ Discharge temperature protection | 无/NO |
In order to solve this problem, we choose a smart board to increase the performance of flexibly setting charge low temperature protection and discharge low temperature protection, to set relevant parameters according to actual application requirements.
The case is as follows
When the charging temperature is at 0 degrees, it will not continue to be charged
When the discharge temperature is at -30 degrees, it cannot be discharged continuously